Replacing/repairing rear wheel tire – Invacare TRACER EX2 User Manual
Page 47
8 REAR WHEELS
47
Permanent Axles
1.
Remove the dust cap (SA Frame only), hex screw, washer (SA
Frame only), spacer (if installed) and locknut that secure the rear
wheel to the wheelchair frame.
2.
Repeat STEP 1 for the opposite rear wheel if desired.
3.
To reinstall the rear wheel(s) onto the wheelchair, reverse STEPS
1-2 and torque locknut to 40 ft.-lbs.
4.
Adjust wheel locks. Refer to Using/Adjusting Patient Operated
FIGURE 1 Removing/Installing Rear Wheels - Permanent Axles
8.2
Replacing/Repairing Rear Wheel Tire
ƽ
WARNING
This procedure MUST be performed by a qualified technician.
If replacing the same size rear wheel, note the mounting position on the wheelchair frame for proper reinstallation of the
new rear wheel.
The spacer is used on wheelchairs with removable arms
only.
Rear Wheel
Washer
(SA Frame
ONLY)
Dust Cap
(SA Frame ONLY)
Hex Screw
Spacer (Wheelchairs
with Removable
Arms ONLY)
Wheelchair
Frame
Locknut
Axle Mounting Axle
ƽ
WARNING
Replacement of the rear wheel tire MUST be performed by a qualified technician.
As with any vehicle, check the wheels and tires periodically for cracks and wear. Replace if damaged.