Using the horn, Elevating the seat – Invacare Wheelchair Pronto M61 User Manual
Page 31
SECTION 5—WHEELCHAIR OPERATION
31
Pronto® M51™and M61™with SureStep®
FIGURE 5.3 Adjusting the Speed
Using the Horn
NOTE: For this procedure, refer to
FIGURE 5.4.
1. Press the horn button located in the
center of the speed indicator. The horn
will sound for as long as the button is
pressed.
FIGURE 5.4 Using the Horn
Elevating the Seat
ƽ WARNING
DO NOT operate wheelchair on an incline while in an elevated position. Otherwise,
the wheelchair may tip over and injury or damage may occur.
DO NOT operate the elevate function near or under a fixed object such as a table
or desk.
Use only the MK660 w/ACC controller to activate the elevate function. DO NOT
use any other actuator controls. Such devices may result in excess heating and
cause damage to the actuator and associated wiring and could cause a fire, death,
physical injury or property damage. If such devices are used, Invacare shall not be
liable and the limited warranty is void.
The elevated seat option is equipped with a speed reduction safety mechanism.
While the seat is in an elevated position, the safety feature slows the speed of the
wheelchair by 80%. If the wheelchair operates at maximum speed while in an ele-
vated position, DO NOT operate the wheelchair. Have the wheelchair serviced
immediately by a qualified technician.
Tortoise Button
Hare Button
Larger Bar in Speedometer
Smaller Bar in Speedometer
NOTE: SPJ™+ w/ACC
joystick shown. SPJ+ joystick
works the same way.
Horn
Button
NOTE: SPJ+ w/
ACC joystick
shown. SPJ+
joystick works
the same way.