Invacare Wheelchair Pronto M61 - Manual (Page 54)

SECTION 9—FRONT RIGGINGS
Pronto® M51™and M61™with SureStep® 54 Part No 1125085
FIGURE 9.7 Adjusting/Replacing Telescoping Front Rigging Supports - Standard Seat
ASBA Seat
NOTE: For this procedure, refer to FIGURE 9.8 on page 55.
1. Remove the two mounting screws, spacers and locknuts that secure the telescoping
front rigging support to the seat frame.
2. Perform one of the following:
• Slide existing telescoping front rigging support to one of three depth positions.
• Remove existing telescoping front rigging.
3. Secure telescoping front rigging at desired depth with existing two mounting screws,
spacers, and locknuts. Securely tighten.
FRONT RIGGING
MODEL
STANDARD
POSITION
1 INCH OUT 2 INCHES OUT
18 inches
wide
20 inches
wide
18 inches
wide
20 inches
wide
18 inches
wide
20 inches
wide
PHW93
Holes
4 and 5
Holes
4 and 5
Holes
5 and 6
Holes
5 and 6
Holes
6 and 7
Holes
6 and 7
PH904A and PHAL4A
Holes
3 and 4
Holes
3 and 4
Holes
4 and 5
Holes
4 and 5
Holes
5 and 6
Holes
5 and 6
Spacer
Telescoping Front
Rigging Support
Mounting Holes
Locknuts
Mounting Bolts
Seat Frame
Inner Mounting Holes
2
Not Used
4 3
5
7
8
6
Hinge
Pins
8