Section 6—arms, Removing/installing the arms, Adjusting the arms – Invacare Wheelchair Pronto M61 User Manual
Page 36
SECTION 6—ARMS
Pronto® M51™and M61™with SureStep®
36
SECTION 6—ARMS
ƽ WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
Removing/Installing the Arms
ƽ WARNING
Increasing the width of the arms may affect the overall width of the wheelchair.
Ensure that there is enough clearance when attempting to pass through doorways
or other tight spaces, otherwise serious injury or damage may result.
NOTE: For this procedure, refer to
FIGURE 6.1.
NOTE: Reverse this procedure to install the
arms.
1. Loosen lock knob that secures the arm
to the arm support tube.
2. Remove the arm from the arm support
tube.
3. If necessary, repeat STEPS 1‐2 to
remove the other arm.
FIGURE 6.1 Removing/Installing the Arms
Adjusting the Arms
Adjusting Width
NOTE: For this procedure, refer to FIGURE 6.2.
1. Loosen the two lock knobs that secure
the arms to the arm support tube.
NOTE: Both arms should be adjusted to the
same distance away from the arm support tube.
NOTE: Changing the width of the arms may
also affect the overall width of the wheelchair.
2. Reposition the arms until desired
width is achieved.
3. Securely tighten the two lock knobs
that secure the arms to the arm support
tube.
FIGURE 6.2 Adjusting Width
Arm
Lock Knob
Arm Support Tube
Seat
Arm
Lock Knob
Arm Support Tube
Seat