Invacare Wheelchair Pronto M61 - Manual (Page 39)

SECTION 6—ARMS
Part No 1125085 39 Pronto® M51™and M61™with SureStep®
Positioning/Adjusting Flip Back Armrests
NOTE: For this procedure, refer to FIGURE 6.6 on page 39.
Positioning Flip Back Armrests for User Transfer
1. Unlock the flip back armrest by pulling the armrest release lever into the up
(horizontal) position.
2. Pull up on the flip back armrest and remove the armrest from the front arm socket.
3. Continue to pull up on the flip back armrest until the armrest is out of the way.
4. Repeat STEPS 1‐3 for opposite flip back armrest, if necessary.
Positioning Flip Back Armrests for Use
1. Make sure the flip back armrest release lever is in the up (horizontal) position.
2. Install the flip back armrest into the front arm socket.
3. Lock flip back armrest by pressing flip back armrest release lever into the down
(vertical) position.
4. Lift up on flip back armrest to make sure the armrest is locked in place.
5. Repeat STEPS 1‐4 for opposite flip back armrest, if necessary.
Adjusting Height
1. Unlock top of flip back armrest by pulling height adjustment lever into the up
(horizontal) position.
2. Adjust top of the flip back armrest to the desired height.
3. Lock top of flip back armrest by pushing height adjustment lever into the down
(vertical) position.
4. Lift up on flip back armrest to make sure the armrest is locked in place.
5. Repeat STEPS 1‐4 for opposite flip back armrest, if necessary.
FIGURE 6.6 Positioning/Adjusting Flip Back Armrests
Height
Adjustment
Lever
Flip Back Armrest
Front Arm Socket
Armrest Release Lever
Height
Adjustment
Lever
Locked
(Vertical)
Unlocked
(Horizontal)