Innovation Technology SF6 - Manual (Page 17)

Page 16
16.4
Settings on despatch as found in User Setup
Instrument serial Number P1 Date
Peak Hold (gauge) 0.5 s
Peak Hold (screen) AUX DISP
Display Units E-6 ml/s
Desen. Factor 1 5 x
Desen Factor 2 10 x
Standby Mode Light + sensor
Standby Delay 15 min
RS232 Protocol DTR/DSR
Sound Type HARMONIC
Sound begins at 20% Alarm
Live tick OFF
Filter Threshold 5
Filter Count 10
16.5
A Citizen dot matrix printer type iDP together with a mains transformer is supplied as an
option. Additional printer rolls can be obtained from ISL or from your local computer
printer supplier. Below the paper roll is a DIL switch having 4 switches. With DTR/DRS
selected from the user set-up ALL 4 SWITCHES MUST BE IN THE OFF POSITION.
Switch the printer ON using the side mounted slide switch. The POWER and SEL green
lights should be lit. Press SEL to turn OFF the light and use LF to advance the paper.
Now switch SEL ON and you can now print the stored results by tapping the screen,
entering OPEN OPERATOR LEVEL then DATA PRINTOUT. The printer will then
operate.
Note that if you try to print with SEL OFF the screen will show print in progress, and then
time out.
If you have entered your operator or company information in Operator ID see 9.1 page 8
This will appear in the printed message.
16.6 Spares & Consumables:
Description Part No
Sensor probe complete.
P1 100 0000
Steel tipped top-cap (25mm) P1 100 0004 supplied in packs of 3
Filter P1 100 0005 supplied in packs of 10
Manual Iss 07
Software version V1.39BB
Compiled by Mel Vinton.