Inter-Tel INT4000 - Manual (Page 17)

FINDING YOU
R
W
A
Y
5
INT4000 Cordless Telephone User Guide
Basic Message Display Functions
Basic Button Functions
In addition to the buttons identified in the preceding table, your phone has a Special
button (
). Depending on how your telephone system is configured, you may
need to press this key before you dial a feature code.
NOTE: Because the telephone system allows customized feature keys, your phone
may have been reprogrammed so that the feature buttons do not match those
described in this guide.
ALSO: To use the BACKSPACE button, you must pre-program the feature button (fea-
ture code 314) on your phone. Refer to Programming Your Feature Buttons section on
page 56 for details on how to program the BACKSPACE button. Also to use the FOR-
WARD, PREVIOUS, NEXT, or MSG button, your System Administrator must program
them in Database Programming.
ICON FUNCTION ACTION
The connection has been
made between the hand-
set and the base unit. Press to answer or make a call.
The handset ringer switch
is turned off. Press and hold on the side of handset to
turn the ringer on.
The handset battery pack
is low and needs to be
charged. See page 15 for information on charging the battery.
You have received a mes-
sage. See page 34 for instructions on how to listen to the mes-
sage.
BUTTON IF YOU... YOU CAN... PG.
Press Answer a call, place an intercom call,
or hang up. 22
CALL or LINE
Press an unlit key or the flashing key Select an outside line or answer a
call.
23
Press and dial the destination
number
Transfer a call. 27
Press Put a call on hold. 25
Press Change a channel. 18
Press Redial a telephone number or save
the last number dialed. 30
Press Adjust volume during a call or select a
ring tone on standby mode. 44
Press and hold for two
seconds
Turn the ringer on/off. 44
Press Mute the microphone. 25
TALK
ON/OFF MUTE
TALK TALK
XFER XFER
HOLD HOLD
CH CH
REDIAL REDIAL
RING/VOL RING/VOL
ON/OFF MUTE ON/OFF MUTE
ON/OFF MUTE
SPCL