JAI TM-1020 User Manual
Tm-1020 series progressive scan shutter cameras
Advertising
Table of contents
Document Outline
- Notice
- Warranty
- Certifications
- WARNING
- TM-1020 Series Progressive Scan Shutter Cameras
- Operation Manual
- 1 Introduction
- 2 Installation
- 2.1 Getting Started
- 2.2 Camera Setup
- 2.2.1 Heat Dissipation
- 2.2.2 Connector Pin Configurations
- 2.2.2 (a) 12-Pin Connector (LVDS/RS-422 version)
- 2.2.2 (b) 12-Pin Connector (Camera Link Version)
- 2.2.2 (c) Digital Output Connector (LVDS/RS-422 only)
- 2.2.2 (d) Analog Output Connector
- 2.2.3 Shutter Speed Control Dial (LVDS/RS-422 version)
- 2.2.4 RS-232 Communication Cable (LVDS/RS-422 version)
- 2.2.5 Digital Output Cable (LVDS/RS-422 version)
- 2.2.6 Camera Link Cable (CL Versions Only)
- 2.2.7 Power Supplies and Power Cable Setup
- 2.2.7 (a) Power Supplies
- 2.2.7 (b) JAI, Inc. Power Cables
- 2.2.7 (c) Building Your Own Power Cable
- 2.2.7 (d) Attaching the Power Cable to the Connector
- 2.2.8 Attaching the Analog Video Output
- 2.2.9 Attaching the Camera Lens
- 3 Operation
- 3.1 Camera Rear Panel (LVDS/RS-422 Version)
- 3.2 Camera Rear Panel (CL Versions)
- 3.3 Progressive Scanning
- 3.4 Electronic Shutter
- 3.5 Integration
- 3.6 Asynchronous Reset
- 3.6.1 Internal Shutter Speed Control (TM-1020 Series)
- 3.6.2 External VINIT With Pulse Width No-Delay Shutter and ROI (Read-Out Inhibit) (Except TM-1020-15 LVDS)
- 3.6.3 Internal Shutter Speed with Fast Mode (TM-1020-15 only)
- 3.6.4 Internal Shutter Speed with Slow Mode (TM-1020-15 Only)
- 3.6.5 External VINIT with Pulse Width (TM-1020-15 Only)
- 3.7 Dynamic Range Control
- 3.8 Scan Modes
- 3.9 External Sync and Pixel Locking
- 3.10 Camera Timing Charts
- 3.11 Serial Communication Kit
- 4 LVDS-Version Camera RS-232 Commands
- 5 Troubleshooting
- 6 Appendix
- Operation Manual