JAI TM-1020 - Manual (Page 24)

Page 14
TM-1020 Series Progressive Scan Shutter Cameras
Installation
FIGURE 8. 12P-02S Interface Cable (optional)
Note: Make sure that the unused leads are not touching and that there is no possibility that
exposed wires could cause the leads to short.
2.2.7 (c) Building Your Own Power Cable
Refer to the 12-pin connector pin-out in Section 2.2.2 (a on page 6. Connect the Ground lead to pin #1,
and the +12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient
current to properly power the camera.
2.2.7 (d) Attaching the Power Cable to the Connector
The 12-pin connector is keyed and will only fit in one orientation. Follow these directions to properly
attach the power cable to the camera connector:
1. Rotate the connector while applying slight pressure until the keyways line up.
2. Press the connector into place until firmly seated.
3. Plug the power cord into the 100V AC socket. This will power the camera up.
2.2.8 Attaching the Analog Video Output
When connecting the TM-1020 series to an analog frame grabber or a monitor, use the BNC connector
on the rear panel of the camera. The input of the monitor should be balanced for 75
Ω termination.
Standard RG-59 type coaxial cable should carry a full video signal for up to 500 feet. These monitors
are specially modified to accept a 30Hz progressive scan image.
The multi-conductor cable 12P-02S from JAI, Inc. can be used to transmit analog video, power, sync.
signals, and serial communication. The mini coaxial leads in JAI, Inc. multi-conductor cables are
designed for short runs of no longer than 100 feet.
12P-02S Interface Cable
Pin# Lead Color Function Pin# Lead Color Function
1 Gray GND 7 Black coax VD Input
2 Yellow +12V DC 8 White coax shield Strobe out
3 Red coax shield GND 9 White coax HD Input
4 Red coax Video Out 10 Brown RXD (RS-232)
5 Orange coax shield GND 11 Blue Integration
6 Orange coax VINIT IN 12 Black coax shield TXD (RS-232)
HD In (White Coax)
Video Out (Red Coax)
VD In (Black Coax)
Power (Yellow)
+12 V
Monitor
Analog
Frame Grabber
GND (Gray)
}
Male