Mode adjust – JBL AV1 User Manual

Page 131

Advertising
background image

AV1

Mode Adjust

5-33

LFE MIX

-20.0dB or -10.0dB to +0.0dB

Controls the output level of LFE information – the .1 channel in a 5.1-
or 6.1-channel input source – that is sent to the audio output labeled
Subwoofer. Low frequencies from up to seven other channels might
be combined with the LFE information to create the subwoofer output
signal, which significantly increases subwoofer output levels. Careful
adjustment of this parameter allows achievement of proper tonal bal-
ance and reduces the risk of subwoofer overload. When the speaker
setup does not include a subwoofer, LFE information is mixed into
speakers for which the corresponding CUSTOM SETUP menu parame-
ter is set to FULL or to the lowest crossover points.

LISTENER POS

-127 to +127

See “PANORAMA CALIBRATION” on page 5-12 for more information.

LIVENESS

30ms to 20.2s

Depends on the SIZE parameter setting. The LIVENESS parameter
adjusts the amount of effect recirculation. Higher settings mimic
more reflective surfaces and increase decay time.

LOW FREQ WIDTH

-25dB to +25dB

Applies low-frequency spatial correction to the input signal. This
correction is applied to uncorrelated input signals below 60Hz.

MASTER LEVEL

-5dB to +5dB

Adjusts the output level of 2-channel LOGIC7-encoded sources.

MID RT

24ms to 24.3s

Works with the BASS RT and SIZE parameters to adjust the amount
of time required for mid-frequency information to decay below
60dB in level.

CAUTION!

Setting the BASS RT, MID RT or SIZE parameters to a high value
may produce undesirable or damaging audio.

OUTPUT LEVELS

Opens the OUTPUT LEVELS menu, which can be used to adjust out-
put levels for the audio output connectors labeled Center, Sub, Side
L/R and Rear L/R. The OUTPUT LEVELS option does not appear on
listening mode menus when the listening mode does not accom-
modate multichannel output signals. Instead, an output-specific
parameter appears. For instance, the Mono listening mode menu
includes a SUB LEVEL parameter.

Option/Parameter

Default Setting

Possible Settings

CENTER

+0dB

OFF, -30dB to +12dB

SIDE L/R

+0dB

OFF, -30dB to +12dB

REAR L/R

+0dB

OFF, -30dB to +12dB

SUB

+0dB

OFF, -30dB to +12dB

(Listening Mode)

MODE ADJUST

OUTPUT LEVELS

Advertising