JVC XM-EX90 - Manual (Page 19)

19
XM-EX90
5 Press £.
Program playback starts.
• If you are operating the main unit, press
‹/8.
Program playback stops after having played all
programmed tracks.
To check the programmed tracks and their order:
Press 4 or ¢ on the remote control unit in stop
mode.
Pressing
¢ shows programmed track numbers in the
order they are programmed (if a track has a title, the
title is displayed before the track number). Pressing
4
shows them in the reverse order.
• The programmed tracks cannot be checked by
pressing 4 or ¢ on the main unit.
To cancel programmed tracks:
Press
&/CANCEL in stop mode.
Each press of &/CANCEL clears the last track in the
program.
If you make a mistake in programming:
Press &/CANCEL in stop mode to clear the last track in
the program until the track you programmed by mistake,
and re-program tracks from that point.
To exit program play mode:
Press PLAY MODE in stop mode and select any play
mode other than PROGRAM.
The program contents remain in memory even after the
program play mode has been exited.
• The program contents are cleared from memory when
the power cord is unplugged or in case of power
failure.
To clear the program:
Press 0. The programmed tracks are cleared at the
moment the MD is ejected.
To play programmed tracks repeatedly:
Combine the program playback and repeat playback to
play the programmed tracks repeatedly.
For the repeat playback, see page 17.
Main unit Remote control unit
/CANCEL
/CANCEL
PLAY MODE
INPUT
EN14-25.XM-EX90[J]/1 98.6.4, 0:06 PM 19