JVC HM-HDS4EK - Manual (Page 14)

Filename [HM-HDS4EK_04Basic.fm]
Masterpage:Left
14
Page 14 April 24, 2003 4:27 pm
INITIAL SETTINGS
Auto Set Up
Auto Channel Set/Auto Clock Set/
Auto Guide Program Number Set
A
Turn on the recorder.
Press 1 on the recorder or remote control.
NOTE:
For a few seconds after you pressed 1 , you can not stop Auto
Set Up, even if you press MENU to cancel this procedure.
B
Perform Auto Set Up.
The AUTO SET/T-V LINK display appears on the front
display panel and/or on the TV screen.
Slide TV/CABLE/SAT switch to the right.
?
Before starting, make sure of the following:
● The TV aerial cable should be connected to the recorder.
● The recorder’s mains power cord should be connected to a
mains outlet.
● The TV should be set to its AV mode.
After the 1 button on the recorder or remote control is
pressed for the first time to power on the recorder, the Auto
Set Up function sets the tuner channels, clock and Guide
Program numbers automatically.
On the front display panel
Press
rt to select “Auto”
and press OK or e .
On the on-screen display
Press
rt to move the
highlight bar (pointer) to
“AUTO SET” and press OK or
e .
“Auto” blinks on the front display panel; do NOT
press any button on the recorder or remote control
until the front display panel shows clock time,
“(CH) 1” or “– –:– –” as illustrated on page 17.
HM-HDS4EK_04Basic.fm Page 14 Thursday, April 24, 2003 4:29 PM