JVC HM-HDS4EK - Manual (Page 19)

Masterpage:Right
19
Filename [HM-HDS4EK_04Basic.fm]
Page 19 April 22, 2003 10:12 pm
Setting satellite receiver’s brand and
channel
After installation, set the satellite receiver’s brand and
channel correctly; otherwise, the Satellite Controller
cannot work correctly.
A
Turn on the satellite receiver.
Turn on the satellite receiver’s power.
B
Access the Main Menu screen on the
recorder.
Press MENU.
C
Access the Initial Set screen.
A Press
w e
to move the arrow to “INITIAL SET UP”,
then press
t
.
B Press
w e
to move the arrow to “INITIAL SET”, then
press OK.
D
Access the Sat Control Set screen.
E
Enter the satellite receiver’s brand.
● Turn on the TV and select the AV mode.
● Slide TV/CABLE/SAT switch to the right.
?
Press
rt
to move the
highlight bar (pointer) to
“SAT CONTROL SET”, then
press OK or
e
.
Press the appropriate number
keys to enter the brand code
from the list on page 20, then
press OK.
● If the brand code you entered
is invalid, the code field will
be reset. Enter the correct
brand code again.
● If the recorder is in playback or
recording mode, you cannot
set the brand code.
HM-HDS4EK.book Page 19 Tuesday, April 22, 2003 10:14 PM