JVC HM-HDS4EK - Manual (Page 90)

Filename [HM-HDS4EK_07Sub.fm]
Masterpage:Left
90
Page 90 April 22, 2003 10:12 pm
SUBSIDIARY SETTINGS (cont.)
Set Stations (A)
Set station names that are registered in your recorder.
A
Select the item.
Press
w r e t
until the item you want begins blinking.
B
Access the Manual Channel Set screen.
Press OK twice.
C
Select the new station.
D
Switch the stations.
Press OK.
● The Confirmation screen appears.
● Repeat steps A – D as necessary.
E
Close the Confirmation screen.
Press MENU.
Set Stations (B)
Set station names other than the ones registered in your recorder.
A
Select the character for station name.
B
Enter the new character.
Press
rt
to cycle through the characters (A–Z, 0–9, –,
f
,
+,
I
(space) ) and stop when the desired character is
indicated, then press
e
to enter. Enter the remaining
characters the same way (maximum of 4). After entering
all characters, press OK.
● The Confirmation screen appears.
● If you make a mistake, press
w until the incorrect character
begins blinking. Then enter the correct character by pressing
rt .
C
Close the Confirmation screen.
Press MENU.
NOTE:
The characters available for the station name (ID) are A–Z, 0–9,
–,
f , +, I (space) (maximum of 4).
Fine-Tuning Channels Already Stored
A
Select the channel to fine-tune.
Press
w r e t
until the channel you want to tune begins
blinking.
B
Access the Manual Channel Set screen.
Press OK twice. The Manual Channel Set screen appears.
C
Perform tuning.
Press
e
until “+/–” begins blinking, then press
rt
until
the picture is its clearest. Then press OK.
● The Confirmation screen appears.
● Repeat steps A – C as necessary.
D
Close the Confirmation screen.
Press MENU.
Perform steps A and C of “Manual Channel Set” on page 88
to access the Confirmation screen before continuing.
Press
e
until the station
name (ID) begins blinking,
then press
rt
until the new
station’s name (ID) you want
to store begins blinking.
Registered station names
(
੬
pg. 91) appear as you
press
rt
.
Perform steps A and C of “Manual Channel Set” on page 88
to access the Confirmation screen and then perform steps A
and B of “Set Stations (A)” in the left column before
continuing.
Press
e
until the first letter of
the station name begins
blinking.
Perform steps A and C of “Manual Channel Set” on page 88
to access the Confirmation screen before continuing.
HM-HDS4EK.book Page 90 Tuesday, April 22, 2003 10:14 PM