JVC HM-HDS4EK - Manual (Page 71)

Masterpage:Right-NoTitle0
71
Filename [HM-HDS4EK_06Edit.fm]
Page 71 April 22, 2003 10:12 pm
NOTES:
● All necessary cables can be obtained from your dealer.
● For Y/C signal input/output, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.
● When you select “EDIT” to dub tapes in step D, be sure to select “AUTO” (or “NORM” when “B.E.S.T.” is set to “OFF”) after you
finish dubbing the tapes.
● When you use this recorder as the source player for editing, be sure to set “O.S.D.” to “OFF” before starting ( ੬
pg. 82).
● If you are using another recorder with S-Video and Audio input/output connectors, you can connect those connectors to this
recorder’s S-VIDEO and AUDIO input/output connectors.
When using your recorder as the source player ...
... connect its rear panel S OUT and AUDIO OUT connectors to the recording deck’s S-Video and Audio input connectors.
When using your recorder as the recording deck ...
... connect its front panel S-VIDEO and AUDIO input connectors to the source player’s S-Video and Audio output connectors. Then,
set the recorder’s input mode to “F-1”, and set “F-1 INPUT” to “S-VIDEO” (
੬
pg. 69).
AV mode
21-pin SCART cable
(not provided)
Recorder Your recorder
Another recorder
Player
TV receiver
A B
AV mode
21-pin SCART cable
(not provided)
Recorder
Your recorder
Another recorder
Player TV receiver
C
Player
Your recorder
Another recorder
Recorder TV receiver
S-Video cable (provided)
21-pin SCART cable (not provided)
HM-HDS4EK.book Page 71 Tuesday, April 22, 2003 10:14 PM