Sony GDM-90W01T - Manual (Page 13)

13
EN
F
D
ES
I
J
2 Press the ¨ ./> button to select and the > ?//
button to adjust the parameter.
H PINCUSHION/ H PIN BAL:
Corrects the picture distortion of the picture edges.
H KEYSTONE:
Corrects the difference of picture size at the top and
bottom.
H KEY BAL:
Corrects the imbalance of picture position at the top and
bottom.
ROTATION:
Corrects the picture rotation.
S PINCUSHION/ S PIN BAL/ C BOW:
Corrects the wavy distortion of the picture edges.
FLARE TOP/ FLARE BOT:
Corrects the flare distortion of the picture at the top and
bottom.
V LINEARITY/ V LIN BAL:
Corrects the vertical linearity and the vertical linearity
balance.
The OSD automatically disappears after about 30 seconds.
To turn off the OSD, press the Dd button again.
To reset, press the ? (reset) button while the OSD is on.
The selected parameter is reset.
Adjusting the screen
1
Press the button.
The “SCREEN” OSD appears.
2
Press the ¨./> button to select and the >?//
button to adjust the parameter.
H CONVERGENCE/V CONVERGENCE:
Adjusts the horizontal convergence and the vertical
convergence.
The adjustment data becomes the common setting for all
input signals received.
V CONV TOP/V CONV BOT:
Adjusts the vertical convergence at the top and bottom
of the screen.
The adjustment data becomes the common setting for all
input signals received.
H FOCUS:
Adjusts the horizontal focusing.
The adjustment data becomes the common setting for all
input signals received.
Adjusting the picture
centering and size
The adjustment data becomes the individual setting for each
input signal received.
1 Press the Å button or the button.
The “CENTER/SIZE” OSD appears.
2
Press the ¨./> button to select and the > ?//
button to adjust the parameter.
H CENTER:
Adjusts the picture position in horizontal direction.
V CENTER:
Adjusts the picture position in vertical direction.
H SIZE:
Adjusts the picture size in horizontal direction.
V SIZE:
Adjusts the picture size in vertical direction.
The OSD automatically disappears after about 30 seconds.
To turn off the OSD, press the
Å or button again.
To reset, press the ? (reset) button while the OSD is on.
The selected parameter is reset.
Adjusting the picture
rotation and the pincushion
The adjustment data becomes the individual setting for each
input signal received.
1 Press the Dd button.
The “GEOMETRY” OSD appears.
S P I NCUSH I ON
S P I N BAL
C BOW
FL ARE TOP
F L ARE BOT
V L I N BAL
SELECT ADJUST
V L I NEAR I TY
93
0
75
0
75
H P I N BAL
H KEYSTONE
H KEY BAL
ROTAT I ON
H P I NCUSH I ON
GEOMETRY
93
42
50
75
100
33
10
EXPERT
CENTER / S I ZE EXPERT
2 3
SELECT AD JUST
V S I ZE
H CENTER 1 0
1 0
2 3
H S I ZE
V CENTER
SCREEN
H CONVERGENCE
V CONV TOP
OFF ON
SELECT SET / AD JUST
H FOCUS
CANCEL MO I RE
MO I RE ADJ
LAND I NG
8 5
7 2
1 0 0
50
0
V CONVERGENCE
EXPERT
7 5 V CONV BOT
ON
AD JUST
DEGAUSS
(continued)