Sanyo XG-705A - Manual (Page 29)

29
4. Wired LAN Configurations
Click
the Add NetworkModule button
Enter IP Address screen
Add NetworkModule screen
When set up the projector where separated by the router and the segment is different;
Projector will not be found nor displayed. In this case, the projector needs to be searched
directly by the IP address.
1. Click the Add NetworkModule button in the Advanced Settings menu. The Add
NetworkModule screen will appear.
2. Click “Add” then the Enter IP address screen will appear. Enter the IP address and click
“OK”. The projector will be added on the Add NetworkModule screen. If you check “Check
status”, the connected projector will be checked periodically.
3. Click “OK” then the projector will be added on the Network Projector List.
Network Projector List