Sanyo XG-705A - Manual (Page 34)

34
5. Wireless LAN Configurations
Insert the USB Wireless LAN Adapter into the USB terminal of the projector. Inserting the
adapter after verifying the shape of the connector in order not to break the terminal.
CAUTION: Use specified USB Wireless LAN Adapter. If you use other product, the projector
will not be operated properly.
Setting Procedures
1. Turn on the projector and select “Wireless” from the input menu of the projector. The
Network connection standby display will appear and the “Please wait...” message will be
displayed. Refer to “3. Names and Functions of the Operation Screen”
➔ “Network
Connection Standby Display” (p.20).
After short time, the message changes to “ Ready for use”. If the USB Wireless LAN Adapter
is not attached to the projector, “Wireless” cannot be selected.
2. Select “Wireless Setting” from the projector menu and press the SELECT button.
Select similar environment between LAN 4 and LAN 5 with the Point 7 8 buttons. (LAN 4,
LAN 5, and SIMPLE* are factory default settings. Select similar environment to the
installation location. For each settings, refer to the chart on page 38.)
✳ “SIMPLE” mode is used for simple setting without complicated LAN setting procedures to
connect to the Wireless LAN. See “Easy Setting” (pp.36–37) for details.
Attaching the USB Wireless LAN Adapter
With Easy setting, you can make Wireless LAN settings easily without any complicating settings
(p.36).
Set the Wireless LAN network through the projector menu.
Detailed network settings will be made with browser. Refer to “6. Configurations with Browser”.
(p39–54) Complete the settings described in this chapter before performing the steps in “6
Configurations with Browser.”
Setting the Network Environment
USB USB
USB Terminal
USB Wireless LAN Adapter
USB Lamp
After the USB Wireless LAN
Adapter becomes ready for use,
the lamp will start to blink green
when receiving data.