Sanyo XG-705A - Manual (Page 94)

94
11. Appendix
■ Cannot start up the browser
Is connection between PC and the projector with NetworkModule Client (or NetworkModule
Moderator) established?
No........Check settings for Wireless/Wired LAN.
Yes ....Check settings of the proxy setting at browser. Refer to “6. Browser
Configurations” (p.40).
■ Although connection between PC and the projector is established, images are
not projected on the screen.
Make sure Wireless/Wired is selected from the Input source menu of the projector.
■ The projector/PJ Controller cannot be turned on/off.
Make sure the settings of the projector are correct to use the projector with it.
Refer to “10. How to Use the PJ Controller”
➔ “ Power and Status” (pp.78–79).
■ Speed of playing back images are very slow.
When connecting on AdHoc mode, check which Wireless channel you are using.
If the computer using the same channel as yours is existing closely, the networking speed
may be diminished or the communication unstable. Change channel to resolve the problem.
The channels of the projector and projector Client computer must be the same. Or adjust the
Quality selection in the Advanced settings.
Refer to “7. Project the Image via the Networks” (p.56).
■ Wired/Wireless input cannot be changed.
NetworkModule Client (or NetworkModule Moderator) cannot be operated.
After selecting “Setting menu”
➔ “factory default” in the projector menu, all the projector
and network settings you have made (such as password or projector name etc.) will go back
to the factory default settings.
■ Network Viewer does not work with the projector operation.
Make sure the FTP server setting. You need to set the FTP server in advance.
Refer to “9. How to Use Network Viewer”
➔ “3) Operating with the projector” (pp.70–71).