Sun Microsystems Netra 120 - Manual (Page 148)

10-8 Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
10.2 Additional Diagnostic Tests for Specific
Devices
10.2.1 Using the probe-scsi Command To Confirm
That Hard Disk Drives Are Active
The probe-scsi command transmits an inquiry to SCSI devices connected to the
system’s internal SCSI interface. If a SCSI device is connected and active, the
command displays the unit number, device type, and manufacturer name for that
device.
The probe-scsi-all command transmits an inquiry to all SCSI devices connected
to both the system’s internal and its external SCSI interfaces. FIGURE 10-3 shows
sample output from a Sun Fire V120 with no externally connected SCSI devices but
containing two 36 GB Hard Disk Drives, both of them active.
FIGURE 10-2 probe-scsi Output Message
ok probe-scsi
Target 0
Unit 0 Disk SEAGATE ST336605LSUN36G 4207
Target 1
Unit 0 Disk SEAGATE ST336605LSUN36G 0136
FIGURE 10-3 probe-scsi-all Output Message
ok probe-scsi-all
/pci@1f,0/pci@1/scsi@8,1
/pci@1f,0/pci@1/scsi@8
Target 0
Unit 0 Disk SEAGATE ST336605LSUN36G 4207
Target 1
Unit 0 Disk SEAGATE ST336605LSUN36G 0136