Sony CMT-C7NT - Manual (Page 39)

39
MD — Editing
4
Press . or > repeatedly until the
first track number of the two to be
combined appears, and then press
ENTER/YES on the remote.
For example, to combine track 1 to 4, select
4.
5
Press . or > repeatedly until the
second track number of the two to be
combined appears.
6
Press ENTER/YES on the remote.
“Complete!” appears.
Notes
• Tracks recorded in different recording modes
(STEREO, LP2, LP4 or MONO) cannot be
combined.
• If both of the combined tracks have track titles, the
title of the second track is erased.
• If two tracks registered to different groups are
combined, the second track is registered to the
group in which the first track is registered. (The
status of the second track is determined by the
status of the first track.).
Undoing the last edit
— Undo Function
You can use this function to cancel the last edit
and restore the contents of the MD to the
condition before the edit.
Note, however, that you cannot undo an edit if
you do any of the following after the edit:
• Do another edit.
• Start recording.
• Update the TOC by turning off the system or
ejecting the MD.
• Disconnect the power cord.
You cannot undo the S.F Edit Function even if
you use the Undo Function.
1
Press FUNCTION on the remote
repeatedly until “MD” appears in the
display.
2
Press MENU/NO on the remote in stop
mode to display “Edit Menu.”
3
Press . or > repeatedly until
“Undo?” appears in the display.
“Undo?” does not appear, when there is no
editing function that can be canceled.
4
Press ENTER/YES on the remote.
A message appears, depending on the last
edit.
5
Press ENTER/YES on the remote again.
“Complete!” appears.
Second track number
to be combined New track number