Sanyo DRW-500 - Manual (Page 20)

-E19-
5
a
Recording Setup
Record Mode
Auto Chapter
Set Clock
Channel Setup
Press SETUP to exit
HQ
SP
LP
EP
EP+
Current selection
Recording Setup
5
b
Record Mode
Auto Chapter
Set Clock
Channel Setup
Auto CH Scan
Channel List
Modify Channel
Tuner Select
MTS Select
Press SETUP to exit
Recording Setup
5
4
b
Record Mode
Auto Chapter
Set Clock
Channel Setup
Auto CH Scan
Channel List
Modify Channel
Tuner Select
MTS Select
Press SETUP to exit
a
Tuner Select Setup
Tuner Select
Press SETUP to exit
CATV
TV
Current selection
4, 5, a, b
ENTER
This unit is equipped with a channel memory feature which
allows channels to skip up or down to the next channel set into
memory, skipping over unwanted channels.
Before selecting channels, they must be programmed into the
memory. In addition to normal VHF and UHF channels, this unit
can receive up to 125 Cable TV channels. To use this unit with an
antenna, set the “Channel Setup” menu.
Important Note:
• The antenna must be connected to this unit. See pages E8
~ E10.
• You may need extra instructions during this setting. If a
message appears, please follow the instructions displayed
on the TV screen.
• For improvement, on-screen display subject to change
without notice.
Setting “Channel Setup”
1. Open “Recording Setup” screen.
(Repeat steps 1 ~ 5 of “To Set the Clock” on page E18.)
TUNER SETTING
2. Press [p] to select “Channel Setup”.
3. Press [ENTER] (or [a]) to select the sub menu.
4. Press [p] or [o] to select the item.
Auto CH Scan ===> See page E20.
Channel List ===> See page E20.
Modify Channel ===> See page E21.
Tuner Select ===> See the right column.
MTS Select ===> See page E21.
If you use this unit for first time, select “Tuner Select”.
Need help? Call
1-800-813-3435
Tuner Select
Select the antenna system “CATV” or “TV”.
1) Select “Tuner Select”.
2) Press [ENTER] (or [a]).
“Tuner Select Setup” screen appears.
3) Press [a] to select the sub menu.
4) Press [p] or [o] to select “CATV” or “TV”.
5) Press [ENTER]. “
√” appears.
6) Press [b] repeatedly to return to “Recording Setup” screen.