Smart Technologies Unifi 45 - Manual (Page 18)

10 Before Installing Your Unifi 45 Projector Retrofit Kit 99-00881-20 A0
3. If the distance isn’t correct, adjust the center hex screw at the base of the projector boom to raise or lower
the angle of the boom.
TIP
You may find it easier to turn the height adjustment screw if an assistant lifts up the
installed boom.
Lowest Point of
Projector Boom Measure this
distance. Top Edge
of Frame
Center Hex
Screw
Projector Boom
Base Plate
on Wall
Turn Clockwise
to Lower the Boom
Turn Counterclockwise
to Raise the Boom