Smart Technologies Unifi 45 - Manual (Page 45)

99-00881-20 A0 Troubleshooting Your Interactive Whiteboard System 37
Troubleshooting Your Interactive Whiteboard System
In this Chapter
This chapter deals with basic troubleshooting issues for your SMART Board interactive whiteboard system
that you can easily solve. For more complex issues, or issues not mentioned in this section, please contact
your authorized SMART reseller and consult the SMART technical support website.
• System Warning Lights (page 37)
– Extended Control Panel (ECP) Ready Light and System Status (page 37)
– Projector Ready Lights and Projector Status (page 38)
• Contacting SMART Technical Support (page 38)
System Warning Lights
Extended Control Panel (ECP) Ready Light and System Status
The ECP ready light is located on the ECP’s main power button. This button also functions as your status
warning light.
Ready light Status
Off The projector system is not receiving power. Check your power cord
and power supply. If nothing changes after checking your power cord,
power supply and main power switch at the back of the projector, call your
authorized SMART reseller to solve the problem.
Solid amber The projector is receiving power but it is in Standby mode.
Flashing green The projector is receiving power and is starting up.
Solid green The interactive whiteboard system is on.
Flashing amber The interactive whiteboard system is cooling down and preparing to enter
Standby mode.