Smart Technologies Unifi 45 - Manual (Page 42)

34 Maintaining Your Unifi 45 Projector System 99-00881-20 A0
1. Complete the last step of the replacement projector lamp instructions.
2. Attach the projector plate to the projector using the three screws
that you removed from the projector plate assembly.
3. Put the projector plate assembly back on the projector boom by attaching
the projector plate hinge channel to the corresponding flange hook
on the projector boom.
4. Hold on to the projector plate assembly firmly when raising the assembly.
5. Raise the projector plate assembly while keeping it attached
to the flange hook. Pass the threaded rod through the attachment
hole on the projector boom, and then secure the projector by
attaching and screwing the thumbscrew that you removed
from the projector plate assembly to the threaded rod.
6. Plug in the power cord and all the connector cables.
7. Turn on the projector’s master power switch, and then press
the power button on the ECP to start up the system.
8. You might need to realign the image after you replace
the projector plate assembly. Turn the thumbscrew
to adjust the level position, while firmly holding the projector.
Refer to the installation guide for further adjustment instructions.
1. Press the power button on the ECP to put the projector back in Standby mode. The power button light
will be solid amber.
2. Press the up button on the remote control for approximately 10 seconds. When the projector beeps,
press the down button on the remote control for approximately 10 seconds. The lamp timer clears
after another beep.
3. To confirm that the lamp timer has been reset, press the MENU button on the remote control.
Scroll to the Status Display menu heading, and then confirm that OH appears in the Lamp timer field.
4. After confirming that the lamp timer has been reset, put the system in Standby mode by pressing the power
button on the ECP.
5. Wait for the system to enter Standby mode, turn off the projector’s master power switch
to shut off the system, and then turn on the projector’s master power switch.
6. When you are ready to use the system, press the power button on the ECP to start up the system.
To replace the projector plate assembly on the projector boom
To reset the lamp timer