Symbol Technologies DS6708 - Manual (Page 250)

14 - 26 DS6708 Digital Scanner Product Reference Guide
Setup Field(s)
Send Data (continued)
Send Next 19 Characters
Send Next 20 Characters
Table 14-1 Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character Scan the Move Cursor To Character on page 14-27 , then any
printable ASCII character from the Alphanumeric Keyboard beginning
on page 14-86 . When this is used, the cursor moves to the position
after the matching character. If the character is not there, the rule fails
and ADF tries the next rule.
14-27
Move Cursor to Start of Data Scan this bar code to move cursor to the beginning of the data. 14-27
Move Cursor Past a Character This parameter moves the cursor past all sequential occurrences of a
selected character. For example, if the selected character is ‘A’, then
the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan the
Move Cursor Past
Character on page 14-27 , then select a character from the
Alphanumeric Keyboard beginning on page 14-86 . If the character is
not there, the cursor does not move (i.e., has no effect).
14-27
Skip Ahead “N” Characters Scan one of these bar codes to select the number of positions ahead
to move the cursor. 14-28
Skip Back “N” Characters Scan one of these bar codes to select the number of positions back
to move the cursor. 14-29
Send Preset Value Send Values 1 through 6 by scanning the appropriate bar code.
These values must be set using the prefix/suffix values in
Table 7-4
on page 7-19 .
Value 1 = Scan Suffix
Value 2 = Scan Prefix
Values 3-6 are not applicable
14-29