Symbol Technologies DS6708 - Manual (Page 89)

Chapter 7 RS-232 Interface
Chapter 7
RS-232 Interface
Introduction
This chapter describes how to set up the digital scanner with an RS-232 host. The RS-232 interface is used to
connect the digital scanner to point-of-sale devices, host computers, or other devices with an available RS-232
port (e.g., com port).
If the host is not listed in Table 7-2 , refer to the documentation for the host device to set communication
parameters to match the host.
Throughout the programming bar code menus, default values are indicated with asterisks (
*
).
NOTE T he digital scanner uses TTL RS-232 signal levels, which interface with most system
architectures. For system architectures requiring RS-232C signal levels, Symbol offers different
cables providing TTL-to-RS-232C conversion. Contact the Symbol Support Center for more
information.
*
Baud Rate 57,600 Feature/Option
*
Indicates Default
NOTE
Most computer monitors allow scanning the bar codes directly on the screen. When
scanning from the screen, be sure to set the document magnification to a level where the bar code
can be seen clearly, and bars and/or spaces are not merging.