Sony DHR-1000 - Manual (Page 10)

10 Getting Started
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If
your TV is listed in the table below, set the appropriate manufacturer’s
code number.
1 Set [TV] / [VTR] at the top of the remote commander to [TV].
2 Hold down POWER, and enter your TV’s code number(s) using the
number buttons. Press the ENTER button. Then release POWER.
Now you can use the POWER, VOL +/–, CH +/– and TV / VTR
buttons to control your TV. To control the VCR, reset [TV] / [VTR] to
[VTR].
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time
until you find the one that works with your TV.
Manufacturer Code number
Sony 01
Akai 04
AOC 04
Centurion 12
Coronado 03
Curis-Mathes 12
Daytron 12
Emerson 03, 04, 14
Fisher 11
General Electric 06, 10
Goldstar 03, 04, 17
Hitachi 02, 03
J.C.Penney 04, 12
JVC 09
KMC 03
KTY 03, 04
Magnavox 03, 08, 12
Marantz 04, 13
MGA/Mitsubishi 04, 12, 13
NEC 04, 12
Manufacturer Code number
Panasonic 06, 19
Philco 03, 04
Philips 08
Pioneer 16
Portland 03
Quasar 06
Radio Shack 05, 14
RCA 04, 10
Sampo 12
Samsung 03, 12
Sanyo 11
Scott 12
Sears 07, 11
Sharp 03, 05, 18
Sylvania 08, 12
Teknika 03, 08, 14
Toshiba 07
Wards 03, 04, 12
Yorx 12
Zenith 15
Notes
• If the TV uses a different
remote control system from
the one programmed to
work with the VCR, you
cannot control your TV with
the remote commander.
• If you enter a new code
number, the code number
previously entered will be
erased.
• When you replace the
batteries of the remote
commander, the code
number automatically resets
to 1 (Sony). Reset to the
appropriate code number.
Step 2: Setting up the remote
commander (continued)