Sony DHR-1000 - Manual (Page 72)

Editing 72
7
Press START / PAUSE.
The whole screen appears and assemble
editing starts.
When editing ends, this VCR is set to
recording pause and the screen in step 6
reappears.
To assemble edit more than 10 events
1 Press ASSEMBLE.
The assemble editing mode is canceled, and the IN/OUT points
stored in memory are erased.
2 Repeat steps 2 to 7.
To stop assemble editing
To stop while editing, press START/PAUSE.
This VCR is set to recording pause, and you can check the events or
change the recording starting point.
When you press START/PAUSE again, editing restarts from the first
event.
To end assemble editing
Press ASSEMBLE.
All the IN/OUT points are erased.
Editing with LANC cable
Assemble editing (continued)
Note
• The recording does not stop
the moment you press p to
stop editing. The source
picture may be recorded a
little longer than you
expected.