Sony DHR-1000 - Manual (Page 63)

Editing 63
Selecting the connection for your VCR
Before editing, check whether the other VCR has a lLANC jack or not.
The operating procedures differ depending on whether or not you make
the lLANC connection.
To use the assemble editing feature, you need to connect to a VCR
equipped with a lLANC jack.
When using this VCR as the playback machine
In the following pages, editing procedures are explained using this VCR
as the recording machine. To use this VCR as the playback machine,
note the following:
• When connecting the lLANC jack, set LANC MODE in the
ADVANCED OPTIONS menu to “S” (page 54).
• If the other VCR has the time code function, press DISPLAY on this
VCR so that the time code counter appears in the display window.
• If you play back an audio dubbed tape and connect the other VCR to
this VCR’s LINE OUT jacks, set the AUDIO MONITOR selector on
the VCR to MIX. Then select the precise balance between the tracks
with the AUDIO MIX BALANCE control.
For further instructions, refer to the manual of the recording VCR or the
editing controller.
Does the other VCR have a lLANC jack?
Yes / go to “Editing with LANC cable – Connections” page 64.
No / go to “Editing without LANC cable – Connections” page 77.
(continued)