Sony DHR-1000 - Manual (Page 70)

Editing 70
You can select various scenes called “events,” from a source tape and
record them in any order you choose. You can edit up to 10 events at a
time.
Before you start editing, set up the system according to the instructions
on pages 64 to 66.
Looking at the Edit Window
The Edit Window appears during assemble editing and shows the
events you have chosen. 5 events are displayed at a time for a total of
10 events.
Editing with LANC cable
Assemble editing
Tip
• If you do not want to
display the edit window, set
EDIT WINDOW in the
ADVANCED OPTIONS
menu to OFF (page 54). The
editing procedure is the
same as when editing with
the Edit Window.
Note
• Horizontal lines may appear
in the top left (or right)
screen. However, this will
not affect the edited picture.
Picture of the
other VCR
MARK
( (PLAY)
PLAYER
P (PAUSE)
RECORDER
Shuttle ring/
Jog dial
Indicates for the status of the
other VCR
If you press RECORDER to
select this VCR, the picture of
this VCR is displayed on the
right, and the IN/ OUT points
and the total recording time
are displayed on the left. (The
characters will be indicated in
grey.)
ASSEMBLE
START/
PAUSE
EVENT BACK
EVENT FWD
IN (recording start) point
OUT (recording end) point
Total recording time
Events
Upper screens show the IN points.
Lower screens show the OUT points.
Tape counter/ time code
Shows the tape counter or time
code of this VCR.