Sanyo PLC WXU700A - Manual (Page 31)

31
Computer Input
Choose Computer  by pressing the INPUT button on the top control or press the COMPUTER button on the
remote control.
Before using these buttons, correct input source should be selected through Menu operation as described
below.
Input Source Selection (Computer : RGB)
Direct Operation
Menu Operation

Note:
When the Input Search function is set to On1 or On,
the input signal will be searched automatically (p.48).
1

3
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select Input and
then press the Point ► or the SELECT button.
Use the Point ▲▼ buttons to select Computer  and
then press the SELECT button.
When Computer  is selected, analog RGB input
source will be selected directly.
Input Menu
Top Control
INPUT button
Computer 1
HDMI
Computer  
S-video
COMPUTER button
Remote Control
Computer 1
Computer  
Network
Video
 COMPUTER  can not be selected when using the COMPUTER IN 2/
MONITOR OUT terminal as MONITOR OUT output.