Sanyo PLC WXU700A - Manual (Page 54)

54
Setting
Arrow
Pointer Pointer
You can emphasize a part of the projected image with this
function. Use the Point ▲▼ buttons to choose Spotlight
( Large, Middle or Small) , Arrow, Finger or Dot and press
the SELECT button. See "Pointer Function" on page 14.
Standby mode
This function is available when operating the projector via
network.
Network .... Supply the power to the network function even
after turning off the projector. You can turn on/
off the projector via network, modify network
environment, and receive an e-mail about
projector status while the projector is powered
off.
Eco ............ Select Eco when you do not use the projector
via network. The projector’s network function
will stop when turning off the projector.
Refer to the owner’s manual of “Network Set-up and
Operation”.
 Note:
• Factory default is Network.
• When selecting Network, the cooling fans may be running
depending on the temperature inside the projector even if
the projector is turned off.