Sanyo PLC WXU700A - Manual (Page 71)

71
Appendix
– Check PC adjustment or Screen and adjust them.
See pages 34-35, 38-39 .
– PIN code lock is being set. Enter a PIN code (" 134" or numbers
you have set). See pages 22, 59-60.
– Make sure your computer is connected to the projector with USB
cable. See page 17.
– Check cable connection between the projector and your computer.
See page 17.
– Check the batteries.
– Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 58.
– Unlock the Key lock function for the remote control function. See
page 59.
– Check RESET/ON/ALL-OFF switch on the remote control is set to
ON. See page 12.
– Check the status of the projector with referring to "Indicators and
projector Condition". See page 75.
– Check the connection between the projector and your computer.
– Check the mouse setting on you computer.
– Make sure the mouse driver is installed on your computer,
otherwise, the remote control can not be used as a wireless mouse.
– Make sure the signal is from the computer, otherwise, the remote
control can not be used as a wireless mouse.
– Turn on the projector before turning on the computer.
– Your operation is invalid. Operate correctly.
– The top control is not available if the top control is locked at Key lock
under Security of Setting section. See page 59.
– Contact the dealer where you purchased the projector or the service
center.
The image is distorted or runs off .
PIN code dialog box appears at
start-up .
Page Up/Down function does not
work .
The Remote Control does not work .
Indicator blinks or lights .
Wireless Mouse function does not
work .
The exclamation mark appears on
the screen .
Top control does not work .
Unable to unlock the Logo PIN code
lock, Security key lock or Security
PIN code lock .