Sony MDX-C8500X - Manual (Page 29)

29
Changing the sound and
display settings
The following items can be set:
SET
•Clock (page 10)
•Beep - to turn on or off the beeps.
•RM (Rotary Commander) - to change the
operative direction of the controls of the
rotary commander.
— Select “norm” to use the rotary
commander as the factory-set position.
— Select “rev” when you mount the rotary
commander on the right side of the
steering column.
•Multi language (language selection) - to
change the display language to English,
French, or Spanish.
•D.Info (Dual Information) - to display the
clock and the play mode at the same time (on)
or to display the information alternately (off).
DIS
•SA (Spectrum Analyzer) - to change the
display pattern of the equalizer display.
•Dimmer - to change the brightness of the
display.
— Select “Auto” to dim the display only
when you turn the lights on.
— Select “on” to dim the display.
— Select “off” to deactivate Dimmer.
•Contrast - to adjust the contrast if the
indications in the display are not
recognisable because of the unit’s installed
position.
•M.Dspl (Motion display) - to turn the motion
display to 1, 2 , or off.
•A.Scrl (Auto Scroll) (page 13)
SND
•EQ Tune (Equalizer tuning) - to adjust the
frequency and volume level of the equalizer
curve.
•Front HPF (High pass filter for the front pre-
output) - to select the cut-off frequency of the
front pre-output.
•Rear HPF (High pass filter for the rear pre-
output) - to select the cut-off frequency of the
rear pre-output.
•SUB LPF (Low pass filter for the subwoofer
output) - to select the cut-off frequency of the
subwoofer output.
1
Press (MENU).
2
Press either side of (DISC/PRST)
repeatedly until the desired item
appears.
Each time you press (–) side of
(DISC/PRST), the item changes as follows:
Example:
Clock t Beep t RM t Multi language t
D.Info t SA t Dimmer t Contrast t
M.Dspl t A.Scrl t Local t Mono t IF t
EQ Tune t Front HPF t Rear HPF t SUB LPF
t Name edit t NameDel t BTM
Note
The displayed item will differ depending on
the source.
Tip
You can easily switch among categories (“SET”,
“DIS”, “P/M”, “SND” and “EDT”) by pressing
and holding either side of (DISC/PRST) for two
seconds.
3
Press either side of (SEEK/AMS) to select
the desired setting (Example: “on” or
“off”).
4
Press (ENTER).
After the mode setting is complete, the
display returns to normal playback mode.