Sanyo CH1852 - Manual (Page 77)

Unit Display and Operation Selector
Remote control receiver This section picks up infrared signals from the remote control unit
(transmitter).
Operation selector
ON position This position is for operating the air conditioner with the wireless
remote control unit.
Set the selector normally in this position.
OFF position Switch the selector to the OFF position if you are not going to use
the air conditioner for a few days or longer.
The OFF position does not disconnect the power. Use the main
power switch to turn off power completely.
TEST position This position is used only when servicing the air conditioner.
CAUTION
Do not set at the TEST position for normal operation.
OPERATION lamp This lamp lights when the system is in the continuous HEAT,
DRY and COOL mode.
TIMER lamp This lamp lights when the system is being controlled by the timer.
ON
OFF
TEST
OPERATION lamp
Operation selector
Remote control receiver
INDOOR UNIT
KHS1852
TIMER
STANDBY lamp
lamp
IMPORTANT
Avoid using radio equipment such as mobile phones
near (within 1 m of) the indoor unit. Some radio
equipment may cause the unit to malfunction.
If the trouble occurs, disconnect power and restart the
air conditioner after a few minutes.
Operation selector
INDOOR UNIT
KHS0951
KHS1251
OPERATION
TIMER
STANDBY
ON
OFF
TEST
6
OI-330-06EG
oi330000
OPERATION TIMER STANDBY
OPERATION lamp TIMER lamp Remote control
receiver
STANDBY lamp
STANDBY lamp This lamp lights during the warm up period for heating and
when the system is defrosting.