Sony CDX-C910 - Manual (Page 12)

12
Actual total number: Sony CDX-C910 (E,S,C) 3-856-715-11 (2)
EN
Changing the sound and
display settings
You can set:
• Amber/Green to change the illumination
colour to amber or green.
• Beep to turn on or off the beeps.
• Dimmer to change the brightness of the
display.
— Select “Auto” to dim the display only
when you turn the lights on.
— Select “on” to dim the display.
• Loud (Loudness) to enjoy bass and treble
even at low volume. Bass and treble will be
reinforced.
• RM (Rotary Remote) to change the operative
direction of the controls of the rotary remote.
— Select “norm” to use the rotary remote as
the factory preset position.
— Select “rev” when you mount the rotary
remote on the right of the steering
column.
• Angle to change the angle of the front panel.
— Select “1” to make the front panel angle at
about 80 degrees.
— Select “2” to make the front panel angle at
about 70 degrees.
• Contrast to adjust the contrast if the
indications in the display are not
recognizable because of the unit’s installed
position.
1
Press (SHIFT), then press (2) (SET UP)
momentarily.
2
Press (2) (SET UP) repeatedly until the
desired setting mode appears.
Each time you press (2) (SET UP), the item
changes as follows:
Clock n Amber/Green n Beep n Dimmer n
Loud
* n RM n Angle n Contrast
* When you turn in the station or listen to the CD/
MD, “Loud” appears.
3
Press (4) (n) to select the desired
setting (for example: on or off).
At “Contrast” setting, pressing (4) (n)
makes the contrast higher, and pressing (1)
(N) makes the contrast lower.
4
Press (SHIFT).
When the mode setting is complete, the
normal playback mode appears.
Turning off the display
You can turn off the display. Even when you
turn off the display, the buttons keep on
illuminating. While the display is turned off,
pressing any of the buttons turns the display
on for five seconds.
1
Press (SHIFT), then press (2) (SET UP) for
two seconds.
2
Press (4) (n) to select “off.”
The display turns off.
3
Press (2) (SET UP) for two seconds.
4
Press (SHIFT).
To turn on the display, select “on” in step 2
above.
Set up
DSPL on SUR EQ