Warning, Avertissement – Superior SLBV-40PM User Manual

Page 25

Advertising
background image

Millivolt SIT Systems

Propane Gas to Natural Gas

Conversion Kits

Models

Catalog No.

SLBV-35

H8271

SLBV-40

H7675

Millivolt SIT Systems

Natural Gas To Propane Gas

Conversion Kits

Models

Catalog No.

SLBV-35

H8270

SLBV-40

H7673

Electronic dEXEN Systems

Propane Gas To Natural Gas

Conversion Kits

Models

Catalog No.

SLBV-35

H8269

SLBV-40

H7671

In Canada:

THE CONVERSION SHALL BE CARRIEd

OUT IN ACCORdANCE WITH THE

REqUIREMENTS Of THE PROVINCIAL

AUTHORITIES HAVING JURISdICTION

ANd IN ACCORdANCE WITH THE

REqUIREMENTS Of THE CAN/

CSA-B149.1 INSTALLATION COdE.

LA CONVERSION dEVRA êTRE

EffECTUéE CONfORMéMENT

AUX RECOMMANdATIONS dES

AUTORITéS PROVINCIALES AYANT

JURIdICTION ET CONfORMéMENT

AUX EXIGENCES dU COdE

d'INSTALLATION CAN/CSA-B149.1.

Gas conversion kits are available to adapt your

appliance from the use of one type of gas to

the use of another. These kits contain all the

necessary components needed to complete the

task including labeling that must be affixed to

ensure safe operation.

GAS CONVERSION KITS

Gas Conversion Kit Installation

Instructions

Step 1. TURN Off THE GAS SUPPLY TO THE

APPLIANCE and disconnect power

supply at the circuit breaker. Ensure

appliance is cold.

CAUTION: THE GAS SUPPLY SHALL BE

SHUT Off PRIOR TO dISCONNECTING THE

ELECTRICAL POWER, BEfORE PROCEEd-

ING WITH THE CONVERSION.

ATTENTION: AVANT d’EffECTUER

LA CONVERSION, COUPEz d’ABORd

L’ALIMENTATION EN GAz, ENSUITE,

COUPEz L’ALIMENTATION éLECTRIqUE.

Step 2. Remove the front glass enclosure

panel. See Figure 25 on Page 20.

Step 3. Carefully remove the logs.

Note: Logs are fragile. Handle gently

to prevent breakage.

Step 4. Refer to Figure 31. Remove the burner

assembly with attached venturi tube.

for Millivolt Systems, continue to Step 5.

for Electronic Systems, skip to Step 8.

Step 5. SIT Millivolt Valve: Refer to Figure 32

and the instructions provided with the

kit.
a. Using a Torx T20 (with 1/4" shank

and center hole), remove and dis-

card the three pressure regulator

mounting screws.

b. Remove the pressure regulator,

spring, poppet, diaphragm and

bushing.

c. discard all removed components.
d. Make sure the rubber gasket in-

stalled on the back of the replace-

ment pressure regulator is properly

positioned. Tighten screws to 25

in.-lb. torque.

Electronic dEXEN Systems

Natural Gas To Propane Gas

Conversion Kits

Models

Catalog No.

SLBV-35

H8268

SLBV-40

H7669

WARNING

This conversion kit shall be installed by a qualified service agency in

accordance with the manufacturer’s instructions and all applicable codes

and requirements of the authority having jurisdiction. If the information in

these instruction is not followed exactly, a fire, explosion or production of

carbon monoxide may result causing property damage, personal injury

or loss of life. The qualified service agency is responsible for the proper

installation of this kit. The installation is not proper and complete until the

operation of the converted appliance is checked as specified in the manu-

facturer’s instructions supplied with the kit.The qualified service agency

performing this installation assumes responsibility for this conversion.

AVERTISSEMENT

Cette trousse de conversion doit être installée par un technicien agréé,

selon les instructions du fabricant et selon toutes les exigences et tous les

codes pertinents de l’autorité compétente. Assurez-vous de bien suivre

les instructions dans cette notice pour réduire au minimum le risque

d’incendie, d’explosion ou la production de monoxyde de carbone pouvant

causer des dommages matériels, des blessures ou la mort. Le tecnicien

agréé est responsable de l’installation de cette trousse. L’installation n’est

pas adéquate ni complète tant que le bon fonctionnement de l’appareil

converti n’a pas été vérifié selon les instructions du fabricant fournies avec

la trousse. Le fournisseur de service qualifié ayant réalisé l'installation

assume les responsabilités liées à la conversion.

Kit part numbers are listed here and the follow-

ing steps detail the conversion procedure. Refer

to the instructions provided with the conversion

kit when performing any gas conversion.

SUPERIOR

®

B-VENT GAS FIREPLACES • MODELS SLBV-35, SLBV-40 • INSTALLATION INSTRUCTIONS

25

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Advertising
This manual is related to the following products: