Sony LBT-ZUX9 - Manual (Page 54)

54 US
Playback does not start.
• Turn off the system, then connect the
USB device again.
• Connect the supported USB device
(page 6).
• Press NX (or N on the remote) to
start playback.
Playback does not start from the first
track.
• The system is in Program Play or
Shuffle Play. Press PLAY MODE on
the remote repeatedly until “SHUF” or
“PROGRAM” lights off from the
display.
Tracks cannot be played back.
• USB storage media formatted with file
systems other than FAT16 or FAT32 are
unsupported.*
• If the USB storage media has been
partitioned, only the MP3 audio tracks
in the first partition would be played
back.
• Files that are encrypted or protected by
passwords, etc. cannot be played back.
• The system can recognized up to
– 997 folders on the USB device
– 999 tracks on the USB device
• The system can play back to a depth of
8 folders.
• The MP3 audio track does not have the
extension “.MP3”.
• The MP3 audio tracks in format other
than MPEG 1 Audio Layer 3 cannot be
played back.
• MP3 audio tracks in MP3 PRO format
cannot be played back.
• The data is not in MP3 format.
* This system supports FAT16 and FAT32, but
some USB storage media may not support all
of these FAT. For details, see the operating
instructions of each USB storage media or
contact the manufacturer.
Tuner
The radio presetting is canceled.
• The power cord is disconnected or a
power failure occurred for longer than
half a day. Redo “Listening to a preset
radio station” (page 31).
There is severe hum or noise.
(“TUNED” or “STEREO” flashes in the
display)
• Set the proper band and frequency
(page 31).
• Connect the antenna properly (page 15).
• Find a place and an orientation that
provide good reception, then set up the
antenna again. If you cannot obtain
good reception, we recommend that you
connect a commercially available
external antenna.
• The supplied FM lead antenna receives
signals along its entire length, so make
sure you extend it fully.
• Locate the antennas as far away from
the speaker cords as possible.
• Try turning off the surrounding
electrical equipment.
• Set the CD/USB power manage
function to “CD/USB POWER OFF”
(page 32).
A stereo FM program cannot be
received in stereo.
• Press FM MODE on the remote
repeatedly until “MONO” lights off
from the display.
Tape deck
The tape does not record or playback,
or there is a decrease in sound level.
• The tape heads are dirty (see “Cleaning
the tape heads” on page 58).
• The record/playback heads are
magnetized (see “Demagnetizing the
tape heads” on page 58).