FARBERWARE COFFEEMAKER FSCM100 - Manual (Page 11)

4. To set Coffeemaker to brew coffee
using Automatic Start-Up feature:
Move the Slider to the AUTO position.
The ON LED will turn off. The AUTO
Indicator Light will illuminate.
(See Figure 6.)
At the programmed time, the
Coffeemaker turn itself on
automatically. The ON LED will turn
on as the Coffeemaker begins
brewing and coffee will begin flowing
into the Carafe.
NOTE: The amount of coffee in the Carafe may be slightly less
than the amount of water placed in the Water Reservoir, since
some of the water is absorbed by the coffee grounds.
5. To serve coffee, remove the Carafe from the Warming Plate.
Always keep the Carafe Lid on the Carafe when pouring
the coffee.
IMPORTANT: When using the Drip Stop Feature while the
Coffeemaker is still brewing, the Carafe must be replaced on
the Warming Plate, under the Filter Basket in less than a
minute to prevent the Filter Basket from overflowing.
6. To keep the coffee hot, place the Carafe back on the Warming
Plate when not serving.
*
AUTO OFF ON
ON HOUR
MIN.
BREW
*
*
FIGURE 6
Activate Auto Start-Up
10
BREWING COFFEE
(Cont.)