Schneider Electric ALTIVAR 58 TRX - Manual (Page 159)

Class 8839 58M Enclosed AC Drives
Factory Engineered Modifications
159
09/2003 © 2000–2003 Schneider Electric All Rights Reserved
Rules:
- Available on all configurations.
Rules:
- Available on all configurations.
- Not available if option E405 is selected.
Rules: Limited to non-bypass drive controllers
Mod
E406
Dual motor overloads and branch short circuit protection
Provides short circuit and overload protection for two motors connected to the output of the drive controller. Includes
overload modules for each motor.
Note: The sum of the total connected motors must not exceed the drive controllers full load ampere rating. Specify
motor FLA values at time of order entry in 'Engineering Notes' field within Q2C.
Mod
E407
Motor A or B contactor alternation scheme
Provides a contactor interlocked for the selection of one motor for load share via a selector switch or rotation timer
scheme.
Note: Specify mode of operation via “Motor A-OFF-Motor B” selector switch, remote contact closure or rotation timer
scheme at time of order entry in 'Engineering Notes' field within Q2C.
Mod
E408
SEMI F47 Power Compliance
Provides a contactor interlocked for the selection of one motor for load share via a selector switch or rotation timer
scheme.
Mod
E409
Line contactor without bypass
Provides a contactor interlocked for the selection of one motor for load share via a selector switch or rotation timer
scheme.
Note: Specify mode of operation via “Motor A-OFF-Motor B” selector switch, remote contact closure or rotation timer
scheme at time of order entry in 'Engineering Notes' field within Q2C.
Mod
E410 Soft Starter Bypass
Provides an Altistart 48 solid stare reduced voltage starter as bypass.
Mod
E411 Reduced Voltage Auto-transformer Bypass
Provides a Class reduced voltage auto-transformer starter as bypass.
Mod
E412
Two High Drive Construction
Provides two drives of the same frame size in a single floor-mounted enclosure. Each drive controller has its own
disconnect and uses a Barriered enclosure design.
Note: Specify Drive arrangement, top mounted drive size and bottom mounted drive size. Each drive must be priced
separately. This option is limited to non-bypass construction. Two High Construction in limited to 1–75 /100 hp
CT/VT