Sony FAX-B140 - Manual (Page 76)

7-10
6
Using remote control __________________________
1 Call home.
2 The outgoing message will be played.
3 Press [#] while the outgoing message is playing. Enter your password when you hear the
beeps indicating that you should enter your password.
When your password is accepted, you will hear a confirmation tone (a short series of beeps).
4 The fax will now accept remote control commands (see List of remote control commands,
p. 7-11).
For example, press [1][1][#] to play back any telephone messages you may have received. When
playback has finished, press [9][9][#] to end the remote control.
5 End the remote control and hang up the handset.
n • A password is required to use the remote control features. However, if PIN ENTRY is set to OFF
(see p. 8-6), it is not necessary to enter your password when you use the FORWARDING MSG
feature (see p. 7-12).
• If you enter an invalid password, you will hear an error tone. If you enter two invalid passwords
consecutively, the call will be disconnected.
• You should enter a remote command within 20 seconds of entering your password. If more than
20 seconds elapse after you enter your password and you do not enter a remote command, the call
will be disconnected.
• The remote control features can be used even when the fax is set to a mode other than TAM
MODE.
• In FAX ONLY MODE, the outgoing message will not be played. Press [#] when the call is
connected.
• In Fax/Tel mode (FAX/TEL AUTO SW), press [#] while the Fax/Tel message is playing. If you
have not set a Fax/Tel message, press [#] when the call is connected.
• In MANUAL MODE, press [#] if MAN/AUTO SWITCH has been set. If MAN/AUTO SWITCH
is off, the fax will ring 15 times. Press [#] while the outgoing message is playing. Then, enter
your password when you hear the beeps.