SATO CL 408e - Manual (Page 134)

Page 7-6
Section 7. Factory Resets
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
7.6 Clear EEPROM
STEP PROCEDURE
1. Record all current dip switch positions, then place all switches in the OFF
position.
2. Place the DSW2-4 in the ON or up postion.
3. Press the LINE and FEED key while simultaneously turning ON the power
switch. When the printer beeps, release the keys. The following screens will
appear.
4. Place the DSW-4 in the OFF postion and the following screen will appear.
5. Press the LINE key to display the next screen.
6. Press the FEED key to display the next screen.
7. Press the FEED key to display the next screen.
8. Press the LINE key to select YES or NO. If YES is selected press the FEED key
to clear the EEPROM .
9. Power OFF the printer and confirm that all switches are in the OFF or down
position.
all clear mode
factory mode
initializing
rom v00.00.00.00
maintenance mode
dipsw2-4 on->off
all clear
counter eeprom
counter all clear
yes no
To clear the EEPROM, perform the following steps.
Caution: Resetting the printer will clear all registers.
counter all clear
completed
all clear mode