SATO CL 408e - Manual (Page 35)

Page 2-15
Section 2. Configuration
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
STEP PROCEDURE
1. Year - The first display shown will have the two digit year selection
underlined. You can scroll through the dates by pressing the LINE
key. The year number will increase by one each time the LINE key is
pressed until it reaches its maximum leagal value (i.e., "99" for the
year digits) at which point it will wrap around to the "00" setting.
2. Month - After you have set the correct year, pressing the FEED key
will advance the underline cursor to the two digit Month position.
You can scroll through the numbers corresponding to the month by
pressing the LINE key. The month number will increase by one each
time the LINE key is pressed until it reaches a value of "12" at which
point it will wrap around to the "01" setting.
3. Day - After you have set the correct month, pressing the FEED key
will advance the underline cursor to the two digit Day position. You
can scroll through the numbers corresponding to the month date by
pressing the LINE key. The date number will increase by one each
time the LINE key is pressed until it reaches a value of "31" at which
point it will wrap around to the "01" setting.
4. Hour - After you have set the correct date, pressing the FEED key
will advance the underline cursor to the two digit Hour position. You
can scroll through the numbers corresponding to the hour (using a 24
hour clock) by pressing the LINE key. The hour number will increase
by one each time the LINE key is pressed until it reaches a value of
"24" at which point it will wrap around to the "01" setting.
5. Minute - After you have set the correct hour, pressing the FEED key
will advance the underline cursor to the two digit Minute position.
You can scroll through the numbers corresponding to the hour by
pressing the LINE key. The minute number will increase by one each
time the line key is pressed until it reaches a value of "60" at which
point it will wrap around to the "01" setting.
6. After you have set the minutes, pressing the FEED key will accept the
setting and advance to the Ignore CR/LF selection.
Set Calendar
(Continued)
LCD Panel — Advanced Mode
calendar
00/00/00 00:00
Calendar
00/00/00 00:00