SATO CL 408e - Manual (Page 83)

Page 4-9
Section 4. Electric Checks and Adjustments
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
4.5b Print Position Adjustment
Using the VR1 potentiometer on the main PCB board.
STEP PROCEDURE
Refer to Section 4.2 for access to main PCB
1.Record all current dip switch positions, then place all switches in the OFF
position and the power switch OFF.
2.Turn VR1 on the main PC Board to the center position.
3.Place DSW2-4 in the ON (up) position.
4.Press the LINE and FEED key while simultaneously turning the power
switch ON.
5.When the printer beeps, release the keys. The following screens will appear.
6.Place DSW2-4 in the OFF (down) position and the screen will display the
next screen.
7.Press the FEED key to display the next screen.
8.Confirm "None" then press the FEED key to display the next screen.
The default is Large.
9.Press the FEED key for a test print. Press the FEED key again to stop
printing.
10.Adjust the position using the VR1 potentiometer and feed another label.
When the adjustment is correct, turn the printer off. If the print position
can't be adjusted with the VR1, replace the Main PCB. Refer to Section 6.
initializing
rom v00.00.00.00
maintentance mode
dipsw2-4 on->Off
factory mode
counter clear
none
print size
small large
test print
press the feed key
VR1 adjustment range is
+/- 3.75mm.