SATO CL 408e - Manual (Page 166)

Page 9-12
Section 9. Optional Accessories
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
STEP PROCEDURE
10. Detach the existing Tension Plate by removing (2) screws. Discard the
screws. Fig. 9-21
11. Position the Tension Plate over the Peel Bar as shown in Fig. 9-20 & 9-22.
12. Attach these parts to the print head bracket using the supplied long screws
in the position previously occupied by the Tension Plate. Fig. 9-23 & 9-24
13. Install the ribbon and adjust the Tension Plate by inserting a flat blade screw
driver in the right side adjusting slot. Move Tension Plate up or down to
eliminate wrinkles in ribbon.
Fig. 9-21
REMOVE RIBBON
TENSION PLATE
8
Fig. 9-22
POSITION RIBBON TENSION
PLATE OVER PEEL BAR
EXISTING RIBBON
TENSION PLATE
Label Dispenser Installation