SATO CL 408e - Manual (Page 51)

Page 2-31
Section 2. Configuration
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
LCD Panel — Service Mode
This selection allows the user to assign a priority for Print Darkness, Print Speed and Print
Offset.
Priority Setting
LCD Command
STEP PROCEDURE
1. Use the LINE key to step to the desired priority. If LCD is selected, the
setting established via the LCD display/menu system will be used for
an incoming label job, regardless of any different command settings.
If Command is selected, any commands in the label job will take
precedence and be used for printing the job and the LCD Display will
reflect the new setting.
2. Once the desired setting is selected, press the FEED key to accept the
setting and advance to the next display.
priority setting
lcd command
ignore can/dle
yes no
This function allows the user to disable:
<DLE> (Hex 10) the print stop command and
<CAN> (Hex 18) the cancel command.
Used for compatibility with some third party hardware and software. It is only displayed
and functional when RS-232C HS serial interface is installed and configured for Status 4
Bi-direction operation.
To exit the Service Mode power the printer off, then back on.
Service Mode service mode
ribbon near end
enable disable
This function is only displayed when a RS232 HS serial interface card is installed and
configured for Status 3 Bi-direction operation. The disable function was added for
compatibility with older non "e" version printers, where ribbon near end was not reported.
Use the LINE key to select Enable or Disable and press FEED to save and exit.