Sharp AL-1670 - Manual (Page 16)

14
GETTING ST
AR
TED
Changing the copy paper size in the tray
1 Gently lift and pull out the paper tray until it stops.
2 Push the pressure plate down until it locks in place.
3 Squeeze the lock lever of the front guide and slide the
front guide to match the width of the paper.
4 Move the left guide to the appropriate slot as marked on
the tray.
● When using 5-1/2" x 8-1/2" copy paper, load it into the upper paper
tray. If the lower tray is used, paper misfeeds may occur.
● When using 11" x 17" copy paper, store the left guide in the slot at the
left front of the paper tray.
5 Load copy paper into the tray.
6 Place the appropriate label to indicate the selected
paper size into the recess on the right front side of the
paper tray.
7 Push the paper tray firmly back into the copier.
Loading copy paper
LOADING COPY PAPER
Front guide
Left guide