Erase – Sharp AL-1670 User Manual
Page 39
37
SPECIAL FEA
TURES
Erase
ERASE
This copier has an edge erase mode and a center erase mode.
●
Edge erase can be used to eliminate shadow lines around the edges of
copies caused when thick paper or a book is used as an original.
●
Center erase can be used to eliminate the shadow produced by the bindings
of bound documents.
●
Edge + center erase can be used to eliminate shadow lines around the edges
of copies and to eliminate the shadow at the center of copies.
●
The erase width can be set from 0" to 1" in five steps using user program
No. 16. See page 49.
●
This feature cannot be used with the 2 in 1 or 4 in 1 feature.
1
Place the original on the original table and close the
document feeder cover.
●
The SPF can also be used for this feature.
2
Use the TRAY SELECT (
) key to select the paper tray
with the desired paper size.
●
The bypass tray and any tray with non-standard size paper cannot be
used for this feature.
3
Press the ERASE key to select the desired erase mode.
●
To select the EDGE + CENTER ERASE mode, press the ERASE key
until both the EDGE and CENTER indicators light up.
4
Set the number of copies and press the START (
) key.
A B
A B
A
A
A B
A B
Center erase
Edge + Center erase
Edge erase