Sharp AL-1670 - Manual (Page 23)

21
MAKING COPIES
Manual
1 Place the original in the document feeder tray or on the
original table.
2 Use the PRESET RATIO selector ( , ) keys and the
zoom ( , ) keys to select the desired copy ratio.
● To select a preset reduction or enlargement copy ratio, press the
or
key repeatedly until the indicator for the desired copy ratio is
lit.
A. Preset reduction ratios are: 95%, 77%, 64%, and 50% .
B. Preset enlargement ratios are: 121%, 129%, 141%, and 200%.
C. Zoom ratios: Any ratio from 50% to 200% can be set, in 1%
increments. Press the
or key to set the approximate
ratio, then press the key to decrease the ratio or the
key to increase the ratio.
● When a zoom ( , ) key is pressed, the ZOOM indicator will
light up and the zoom ratio will be displayed in the copy quantity
display for at least two seconds.
● To verify a zoom setting without changing the zoom ratio, press and
hold down the copy ratio display (
) key. When the key is released,
the display will return to the copy quantity display.
● To decrease or increase the zoom ratio rapidly, press and hold down the
or key. However the value will stop at the preset reduction
or enlargement ratios. To move beyond these ratios, release the key and
then press and hold it down again.
D. Same-size reset: Press the or key repeatedly until
the copy ratio returns to 100%.
3 Ensure that copy paper of the desired size is installed in
the paper tray.
● If you have placed the original on the original table, use the ORIGINAL
SIZE ENTER (
) key to select the original size. Copy paper of
the appropriate paper size will be automatically selected depending on
the original size and copy ratio. If the selected PRESET RATIO
indicator or the ZOOM indicator blinks, the selected copy image is too
large for the copy paper size.
The desired paper tray can also be selected by pressing the TRAY
SELECT (
) key.
4 Set the number of copies and press the START ( ) key.
REDUCTION/ENLARGEMENT/ZOOM
Reduction/enlargement/zoom